10t Single Girder Overhead Crane

10t single girder overhead crane

Specification: 

1. Single girder, box-type shaped by wielding;
2. High quality steel Plate Q235B and Q345B, Q345D for working temperature -40℃;
3. Main girder and end carriage connected by high strength screws;
4. Welding seams are tested by X-ray and ultrasound;
5. Compact structure, small volume and light dead weight;
6. Lifting mechanism is 10t Electric hoist(Single speed, dual speed or European design hoist) ;
7. Good operation performance, step less speed regulating and running smoothly;
8. Main girders Shot blasting sa2.5 after welding to release internal stresses;
9. Painting high quality epoxy zinc-rich primer, and the thickness of oil film is 140μm;

Electric System:
1. Power supply through step less slide lines;
2. Lifting mechanisms and traveling mechanisms are mutually independent and could travel at the same time;
3. Control panel protection degree is IP54;
4. Reasonable components installation, convenient for check and maintenance;
5. Electric cable is suspended in cable saddle, stationary cable trolley which slides on a galvanized C-type steel;

Safety Protection Devics:
Overload limiter, limit switch (lifting and traveling), interlocking protection devices, buffer, track sweep plate, shield, bus bar protection board, anti-collision device, main disconnecting switch, emergency stop system and motor overload protection.

Technical data for single girder overhead crane